loading

We are a leading manufacturer of solar power utilization and lighting systems                   Mob:+86 199 2801 5868

30 meters high lamp manufacturers, in the light and the light, what's the difference?

30 meters high lamp manufacturers, in the light and the light, what's the difference? Suzhou Ann lighting co. , LTD provides 30 meters high lamp manufacturers. Of light and the light difference is mainly reflected in two aspects, first is height, the height of the pole lamp in 13 meters - Between 16 meters, growing



30 meters high lamp' Light, generally refers to more than 15 meters steel conical light pole and high-power modular fixtures are composed of new type of lighting. 】 Manufacturer: the bar' Rod is a play table tennis, cue ball and object ball in line, and two ball distance cannot too big, Otherwise will become the growing effect after long-distance) , the halfway point of the club hit the cue ball, hitting target ball stepmother will still. 】 What is the difference between light and light? Suzhou Ann lighting co. , LTD provides 30 meters high lamp manufacturers. Of light and the light difference is mainly reflected in two aspects, first is height, the height of the pole lamp in 13 meters - Between 16 meters, the height of the light is in 18 m - 40. And then the different maintenance, in the light of light electrical appliances if there is a problem need to maintenance personnel to the top of the light pole for repair, and light lamp panel can be lifting, so the problems of lamps and lanterns lamp panel can be dropped to the ground after repair. In light with the light, almost the same on the surface, and by inserting rod body to meet the height requirements. Light is given priority to with circular plate structure, configuration both with high pressure sodium lamp and metal halide lamp lighting lamps and lanterns. 30 meters high lamp lifting principle in elevating high lamp at the bottom of the rectangle in the inner chamber, in addition to the installation of electrical control system [ Electrical control system generally referred to as the secondary control circuit electric equipment, different devices have different control loops, and high voltage electrical equipment and control way of the low voltage electrical equipment is not the same. 】 Also installed motor such as lifting system. Electrical control system installed inside the light pole, can avoid harsh outdoor environment resulting in failure of lifting movement. In the electric control system is equipped with all kinds of circuit overload protection device. Widely used in circuit in the system of the conductive copper base, silver plated to ensure good contact electrical connection. Lift high lamp lifting system is through the motor, the electromagnetic brake type worm gear and worm reducer, safety couplings, main cable, vice wire rope, the rope, and components, such as driving lamp plate lifting pulley group. Worm gear and worm gear reducer of the self-locking capability is strong, compact transmission, the transmission ratio is large, in order to reduce the worm gear and worm gear ratio, reduce the rising torque, especially to increase a set of pulleys, lamp plate lifting speed is less than zero. 2 m/s. Main wire rope through the points are connected to the lamp panel vice wire rope rope device, can avoid due to the main wire tensile pair wire winding. Lord, vice adopt high strength and corrosion resistance wire rope type 6 * 19 not rotating galvanized steel wire rope. Lifting pulley block is used after galvanizing processing of A3 steel bracket, copper, stainless steel shaft pulley, under the condition of normal atmospheric no rust is flexible in operation. Preparation for 30 meters high lamp 1. According to the loading and packing list carefully counted all artifacts. 2. Check whether the component is damaged, bend, twist, zinc layer is damaged. 3. Each section on the rod body signs indicate the type of the rod body, order number, block number. In the bar side of the body to indicate the weight of the rod body with a marker pen. Is issued by the cargo is correct, the crane lifting capacity is enough. 4. According to the drawing provided by large and small socket length, in the good mark in the rod body, used for the socket. 30 meters high lamp installation

GET IN TOUCH WITH Us
recommended articles
Knowledge News & events Project
ALLTOP Cordially Invites You | Join Us at WETEX 2026 Dubai Solar PV Exhibition to Explore New Opportunities in the Middle East PV & Energy Storage Market!


Exhibition Name: WETEX 2026
Exhibition Dates: October 20–22, 2026
Venue: Dubai World Trade Centre · Dubai, UAE
ALLTOP Booth: 4C14
Warm Invitation | ALLTOP Debuts at the 140th Canton Fair, Jointly Witnessing a New Future of Green Energy

Exhibition Name: The 140th Canton Fair)
Exhibition Dates: October 15–19, 2026
Venue: China Import and Export Fair Complex, Guangzhou, China
ALLTOP Booth: Zone C · Hall 16.4 · Booths C34-C35, D08-D09
Golden Topping-Out Marks a New Milestone, Output Value Exceeds RMB 600 Million! ALLTOP Industrial Park’s 168,800 m² Project Successfully Topped Out

318 Days—Less Than a Year!

At the “Speed of Light,” from Blueprint to Topping-Out.

50.24 mu of Prime Land, 168,366 Square Meters of Intelligent Manufacturing Space,

Annual Output Value at Full Production Exceeding RMB 600 Million.

ALLTOP Speed, Formidable Strength, and a Promising Future!

Golden Topping-Out Shines, Output Value Soars
The Hype Is On! ALLTOP Draws Global Spotlight at the Solar Expo — Join Us for a Chat
SOLAR PV & ENERGY STORAGE WORLD EXPO 2026

Booth No.: 10.2· B551
Time: September 16–18
Address: China Import and Export Fair Complex, Guangzhou, China (No. 382 Yuejiang Middle Road, Haizhu District, Guangzhou)
ALLTOP UGANDA Invites You to Power and Elec Expo 2026

Exhibition Name: Power and Elec Expo 2026

Date: July 9th-11th 2026

Company Name: Alltop Engineering Uganda

Hall No.

Booth No. A45

Venue: UMA Show grounds, Multi-Purpose Hall, Kampala-Uganda
Our aim is to provide the best products and the most considerate service for customers.
About Us
Customer service