30 meters high lamp installation and solar lights which need to be paid attention to detail

30 meters high lamp installation and maintenance: more than 20 meters high lamp by the second quarter splice, 20 meters high lamp arm thick 6/8 ( According to the customer demand customization) More than 30 meters high lamp, composed of three splice, 30 meters high lamp wall thickness 6/8/10 ( According to the customer demand customization) , the following sea



30 meters high lamp' Light, generally refers to more than 15 meters steel conical light pole and high-power modular fixtures are composed of new type of lighting. 】 Installation and maintenance: more than 20 meters high lamp by the second quarter splice, 20 meters high lamp arm thick 6/8 ( According to the customer demand customization) More than 30 meters high lamp, composed of three splice, 30 meters high lamp wall thickness 6/8/10 ( According to the customer demand customization) , sea ray lighting briefly below 30 meters high lamp installation details and matters needing attention.

( 1) First connect the wire hoist lifting system and the main oil fixed in place, and then the main oil tube in turn into the second quarter and the third quarter.

( 2) Plug, the most brick or wood cushion flat bottom section, insert the section two and three respectively each other with the crane, the main oil wire pull on the section 1 m or so, through oil wire connection plate with three deputy oil wire connection, and then the main oil wire from the top down to the oil wire connection plate away from the Plate spacing is a Chinese words, pronunciation is pan ju, refers to the entrenched. 】 The position of the top 50 cm is better, and then for rainhat.

( 3) Poling, three deputy oil silk section and lower flange connection is good, as large as possible using hoist themselves to three quarters limit tightening, ready to 30 meters after the length of the lifting belt, ( Bearing important in 4 tons) Door with flange motor fixed good, then the whole root hoist crane.

( 4) In order to avoid the lamps and lanterns is damaged during lifting, suggested that fission first lamp plate and light pole body well matched then install lamps and lanterns.

( 5) Debugging, lamp plate installed three deputy oil wire connected to the lamp panel, and then start the hoist rises lamp panel, success or failure of test to take off the hook, connected the power and installation.

has seen a lot of light, and built-in pit volume 5 cubic meters, this means that there will be more than 5 party 【 More electric appliance is located in China's largest kitchenware base - — Zhejiang shengzhou to 'the Chinese kitchen', 'China motor of the township', integrating r&d, manufacturing, sales, more electronics is a professional production of high-end lampblack machine, kitchen burning gas, disinfection cabinet, integrated environmental protection kitchen kitchen appliance manufacturers. 】 The embedded parts of the concrete inside, let alone is about 30 meters high lamp, even highly in 35 meters high lamp installed on the basis of such will firmly. '

as for fixed by steel pile and built-in can only say that rich unit, the choice of using steel pile is more solid than screw embedded parts, but not much necessary personal feeling, because of the high cost of after all. Remove the cost of the steel pile itself, still need to transfer the driver to finish the homework when installation, these costs alone fast to catch up with light, a complete set of lamps and lanterns of the cost. Bottom flange parts of the light, the next you can't measure, is because the flange and tube cross section welded together, as long as good welding after who all can't measure. Then there is the link at the top of the circle, this part cannot measure, because the top have a triangular piece of lightning rod fixed plate is covered the diameter full welding on the whole, therefore, there is no way to measure the light, street light manufacturer. But in the middle of the splice segment can be measured, light, anticorrosive technology is hot dip galvanized coating, the thickness of the galvanizing is 85 microns, the thickness of coating is 0. 3 mm, the thickness of the two kinds of process together is close to zero. 5 mm.