3 d model solar street lamps

Solar energy lamp lamps and lanterns should first when installed on each part component is fixed: solar panels fixed on the bracket of solar panels, lamp holder fixed to carry on the arm, then stent with arm fixed to the main stem, and wear the cables to control box ( Battery box) 。 Light pole up

installing a solar energy lamp lamps and lanterns, the first thing to all parts of the fixed parts: solar panels on the solar panel bracket, lamp holder on the cantilever, then stent and cantilever fixed on the main stem, connecting to control box ( A battery pack) 。 Before ascension light pole, check whether the parts fasteners and firm, lamp holder installed correctly, light source is working correctly. Then simple debugging system is working correctly; Loosen the controller on the solar panel cables, light work; Connect the solar panels connecting cable and turn off the lights; At the same time, careful observation of each indicator light on the controller changes; Only when everything is all right, it can be filed and installation. Improve the main lamp pay attention to safety measures; Fully tighten the screw. If there are any deviation component of sunrise view, it is necessary to adjust the components of the direction of sunrise, facing south. The battery into the battery compartment, according to the technical requirements will be connected to the controller; First connect the battery, and then connect the load, and then connect the solar panels; In the process of wiring operation, must pay attention to the controller tags on each of the wiring and terminals can't connection error, positive and negative polarity not conflict, not reverse connection; Otherwise, the controller will be damaged. Debug the system is working correctly; Loosen the controller on the solar panel cables, lights; Connect the solar panels connecting cable and turn off the lights; At the same time, careful observation of each indicator light on the controller changes; Only when everything is normal, the control box can be sealed. In addition, in high lamp when above ground installation, should pay special attention to the installation position of solar panels, and ensure the sufficient sunshine, lest affect the lighting effect of lamps and lanterns. Therefore, when choosing installation location, solar module can illuminate the sun, at any time without any obstacles, such as leaves. The thread, make sure not to wire junction of the lamp. Wire connection should be connected firmly, and PVC tape. In order to ensure that is beautiful and better to receive solar radiation, had better clean once every six months the dust on the battery components, but don't rinse area from the bottom up. The remarkable rapid screen sales promotion