In order to reduce the theft for solar street lamps, can from the following several aspects to strengthen management; 1, higher cost compared with the traditional street lamp, solar street lamps and street lamps in the area of security and stability is not enough mature and perfect, should choose in the city
in order to reduce for the solar street lamps Solar street light is a crystalline silicon solar battery power supply, valve control type sealed and maintenance-free battery ( Gel battery) Store electricity, super bright LED as light source, lamps and lanterns and controlled by the intelligent charging and discharging controller, is used to instead of the traditional public power lighting lamps. 】 Theft, can from the following several aspects to strengthen management; 1, higher cost compared with the traditional street lamp, solar street lamps and street lamps in the area of security and stability is not enough mature and perfect, should choose in the city public places or safer places set up long, not easy to install in suburban areas. 2, pay attention to the safety monitoring of solar street lamps, can be set up to monitor system in easy to steal places or install alarm system, so as to timely know the usage of street lamps for street lights for effective management ( 1) Open circuit voltage of the Voltage of the battery under open circuit state in referred to as the open circuit voltage. 】 Low, closed circuit voltage ( Discharge) Soon to end voltage. ( 2) High discharge current, voltage drop quickly to zero. ( 3) When open, the electrolyte density is low, electrolyte freezing phenomenon will appear in the low temperature environment. ( 4) When charging, the voltage rise slowly, always stay low, Sometimes zero) 。 ( 5) When charging, high electrolyte temperature rises quickly. ( 6) When charging, the electrolyte density rises slowly or almost no change. ( 7) When charging is bubbled or steaming appeared very late. Solar street lamps factory analysis, cause lead battery solar street lamps Commonly used rechargeable batteries in addition to lithium batteries, lead-acid batteries a battery system is also very important. 】 The reason of internal short circuit mainly has the following several aspects: ( 1) Partition quality is bad or defect, make the plate through the active material and the positive and negative plate contact or direct contact. ( 2) Partition into a connected to the positive and negative plates. ( 3) Plate on the active material loss, due to the loss of the active material deposition is overmuch, cause positive and negative plate bottom edge or side edge connected with sediments caused by mutual contact the positive and negative plates.