100 w street light configuration of solar power

High lamp installation speed is generally associated with light source, the number of lamps and lanterns, less number of common light source of light, from the morning to normal before it gets dark, the installation is complete, but more than 25 meters high lamp if there are more than 15 light source of lamps and lanterns, then it will be before it gets dark

high lamp installation speed is often associated with the number of light sources. In general, from the morning to the front of the dark light, can be installed with a small amount of light. However, if a 25 meters high lamp for more than 15 light source, it will not be finished before dark. Sometimes, however, the owner or the government asked in the morning turn on the light, so it is necessary to install in the evening. Install the light in the evening is very dangerous, so everyone in the evening when installing high lamp must be careful. Next, the light manufacturer's technical personnel will tell you how to install the light in the evening. Lift the lamp panel in the evening, we can use a flashlight or lights provide some light to determine the fuzzy height of the lamp panel. Near the top, the operator should pay special attention to. At this time, even more flashlight also can't let you see clearly the location of the hook. At this point, there is only one method can accurately determine whether the lamp panel access to link, that is through listening, when the lamp panel inner ring comes into contact with the hook, will appear the sound of iron and iron friction. The sound is transmitted through the rod body, standing in the following one will be clearly heard. When friction disappears, we will turn the light board up about 3 cm long, and then began to decline. After falling 10 centimeters, we will see if the main wire rope loose. If it is loose, we can determine the hooks have been firmly hang on the lamp panel. Through the installation of light in the evening to determine whether the lamp panel by hooks in, listening is the most accurate method. If no size between the hook and lamp plate unqualified problem, this method can be 100% success. That is how to install light at night. Here, the light manufacturer's technical staff still need to remind you again, when installation should pay attention to the installation of the night, be careful!