10 solar street light

Solar led street light at the bottom of the rectangle in the inner chamber, in addition to the installation of electrical control system is also installed motor such as lifting system. Electrical control system installed inside the light pole, can avoid harsh outdoor environment resulting in failure of lifting movement. Electrical control system in a

in solar led street light at the bottom of the rectangular cavity, in addition to the electrical control system, also installed the motor hoist system. Electrical control system installed inside a light pole, can avoid harsh outdoor environment cause the failure of lifting movement. There are all sorts of circuit in the electrical control system overload protection device. Copper base is widely used in silver plated circuit in the system of electric conductor, to ensure good contact electrical connection. ( 1) New countryside of solar street lamps spacing design led street lamp of the head belong to by the lamp holder, as light direction of maximum light intensity and light downward Angle of 0 degree between vertical axis; 65 degrees; In between, lamps and lanterns of maximum intensity projection direction and the Angle between the vertical lines should not exceed 65 degrees; , the theoretical design light distance = tg65 times; Lamp height times; 2, according to the characteristics of the new rural construction, there is a slight difference, but the gap is too big. ( 2) Lamps and lanterns design ( 1) With reference to the national standard lamps and lanterns, the installation height of cantilever should not be more than a quarter. If the cantilever length is too long, first of all, can reduce installation of kerbstone and the brightness of the pavement (on one side of the lamps and lanterns Intensity of illumination) ； Second, the cantilever need high mechanical strength, which can lead to the lamp and the vibration of light source, affect the service life of them; Third, affect beautiful, cause not harmonious proportion of the cantilever with light, Fourth, the cost will increase, so the cantilever length should not be too long. ( 2) Lamps and lanterns Angle should not exceed 15 degrees; Increase the light Angle will increase to light relative side of the road light, but road brightness will not significantly increased; In particular, the arrangement of the basic ways of traditional lighting equipment provided for when using traditional lighting equipment shall meet the requirements. On the corner, if the elevation of lamps and lanterns is too big, can increase the possibility of glare, light pollution will increase. Therefore, the elevation of lamps and lanterns should be limited. ( 3) Light pole shall not be located in dangerous places or maintenance during serious blocking traffic. ( 4) The new rural construction road night average intensity of illumination should be 15 lx, and to provide appropriate vertical illuminance. Basic structure of concrete, foundation has a fixed light pole flange of flange fixed anchor bolt and anchor bolt. In the foundation, according to the solar street lamps 。 jschindo。 com】 Threading pipe number and diameter of manufacturers requirements, embedded cable threading pipe, hot dip galvanized steel pipe threading pipe adopted. All lever, namely based embedded anchor bolts, fasteners, bolts and nuts, must be made with stainless steel bolts.