10 m and 12 m street lamps - 10 m and 12 m street lamp lighting technical specifications

10 m and 12 m street lamps - 10 m and 12 m street lamp lighting technical specifications of the

1, the street lamp light pole material:

haiyan lighting light pole material made of high quality low carbon steel Q235, after a large bending machine bending forming, the design of the light pole strength can reach more than was 11th grade and anti seismic intensity of 8.

2, street lamp lighting technology parameters:

for conical rod body, the cross section roundness error is less than 3%. On the pole's total 10 meters high, diameter is 80 mm, the diameter is 180 mm, thickness is 3. 75mm。 At the bottom of the light pole with flange, flange size is 350 * 350, thickness of 18 mm, with four anchor bolt is installed on the base. On the pole's total 12 meters high, diameter is 80 mm, the diameter is 200 mm, thickness is 4 mm. At the bottom of the light pole with flange, flange size is 400 * 400, thickness of 20 mm.

3, street lamp lighting technology:

light pole welding forming, welding, according to national standard and inspection basis, to ensure reliable welding, smooth surface, no obvious welding defects such as porosity, flash, bite edge, welding up to level 3 standard welding seam. Light pole inside and outside the hot dip galvanized anti-corrosion treatment, zinc plating process, after washing, phosphating, pickling, galvanizing, passivation process, the surface is bright and clean, uniform zinc layer, guarantee the galvanized layer 85 microns, more than 560 g / ㎡, guarantee the anti-corrosion performance of light pole twenty years. Coating quality conforms to the current national standard 'the metal cover and and other relevant covering vickers and knoop microhardness test' ( GB / T9790) And the general principles of the thermal spraying pretreatment on the surface of the metal ( GB / T11373) , the current industry standard 'steel hot dip aluminum process and quality inspection' ( ZBJ36011） The relevant provisions. Light pole electrostatic pensu after hot dip galvanized, plastic spraying layer 140 microns, plastic spraying coating after no beat, pinhole defects, rough, crack or leak spray area, covering layer and substrate has a strong bonding strength.

4, the technical parameters of street lamps and lanterns:

for die casting aluminum lamps and lanterns, after sand blasting tiny treatment, the surface of polyester powder coating. Light pole insert diameter 60 pipe diameter, LED street lamp head) Insert depth of 100 mm; （ High pressure sodium lamp) Insert depth 135 mm. Lamps and lanterns with sealing strip seal between top and bottom cover, protection grade IP66, light bulbs and appliances respectively before and after the end of the next guy contact with shell well, under the cover of lamps and lanterns before, the back-end of the heat dissipation, good heat dissipation effect. Reflector lamps and lanterns USES polyhedron combination, made from high purity aluminum plate stretch forming, reflective excellent efficiency. Lamps and lanterns USES high transparent, high strength of toughened glass, and use the GE silicone seal under cover and lamps and lanterns, in the bubble structure, lamp holder bracket can be adjusted, the different power of the light source used to install. For stainless steel fasteners, screws, nuts. Light source is 40 - W - 200 wled street light head, 150 400 w high pressure sodium lamp.