Solar street lamps light pole component packaging

Solar street lamp lighting component packaging 1) Use steel seal size will street nameplate fill in the neat and accurate, and clear. Specific installation method as shown in the selection of lamps and lanterns shop nameplate, typing and installation specification '. 2) Pre wear thin wire will be 16 wire wear into the lamp post

solar street lamp lighting component packaging

1) Use steel seal size will street nameplate fill in the neat and accurate, and clear. Specific installation method as shown in the selection of lamps and lanterns shop nameplate, typing and installation specification '. 2) Pre wear thin wire will be 16 wire wear into the lamp pole component, and in the light pole components at each end set aside 300 mm allowance. Use light pole under the bottom of the fine wire cutters bent a tick. 3) Wearing jacket will have prepared light line connect light end using skinning open 30 mm wire stripping pliers, wire core from the light pole components through the thin wire hook of the bottom after returning the wire core tight, then use insulating tape to fix and fine wire line core firm, twitch under the wire at the top of the light pole will light out and set aside 1200 mm to 1800 mm allowance ( According to the lamp arm structure) , will light pole at the bottom of the light source, a coil after putting it in a light pole under the component, the light pole under the top of the line light source fixed on the light pole, pay attention to in the threading process don't touch broken line. Finally put on a thin wire in the light pole and the lamp pole components at each end set aside 300 mm allowance and to fasten on the wire. 4) Set of line do identification under light pole of the bottom of the component sheathed wire strip length is about 200 mm leather sheath, and then on the solar battery components sheathed on both ends of the line to do 'light XXW' logo, LED street lamp, at the same time must ensure that the logo is clear, not easy to fall off. 5) Parcels, tie down the light pole component with a width of 60 cm of the gas film mat light pole components, gas film mat part for its pressure to one 6 of the width ( The 10 cm) , gas film mat need joint huang gelatin wrappest 3 laps, and then the rope winding, spacing for 100 + 10 mm.