New led street light

Once installed solar street lamps, all anxious to see light effect, after the completion of the installation will light on test results. Under normal circumstances, the day after installing solar street lamps generally don't recommend direct electric lights. Because the new battery in the factory time

after installing solar street lamps, everyone is eager to see the lighting effects, lighting effect of test will be carried out after the installation is complete. Under normal circumstances, generally do not recommend the installation directly open the solar street light on the day. Because the new battery manufacturer at no charge, if light up after installation, reach design of rainy days. After install the correct method is connecting the controller, rather than the connected load, and the next day charging connection in the evening after a day of load during the day, so the capacity of the battery can achieve a higher level. Solar street light plate Angle generally is designed according to the Angle of 45 degrees, so that can ensure a better charge in winter. But the direction Angle is determined by the installation. When the solar panels in the underground assembly, found that the light pole erected, deviation Angle. If similar deviation, generally do not adjust. ( Solar street lamps) The angular deviation is not only affect the charging, but also affect the voltage of solar panels under the same intensity of illumination, solar street lamp open time error is bigger. Therefore, when assembled on the ground, adjust the orientation Angle of solar panels to keep consistent as far as possible. Another is the connection between the internal components and solar street lamps controller. Street lamp factory lighting solar street lamps factory suggest it is best to use waterproof function of controller, to ensure the long-term stability, and also to prevent users to change the illumination time. If you use the waterproof controller, because the terminal blocks down, so the connection bent into a U shape, so as to prevent water from a line into the controller. Try to use better quality of copper core. Due to the electrical conductivity, current and voltage loss in the process of the output, this not only increases the power consumption, and in severe cases can lead to led drive power supply failure.