Lighting: Can solar landscape street lights be converted into city electricity?

Solar landscape street lights are now the mainstream products in street lighting devices. With their two major advantages of environmental protection and energy saving, Mercedes-Benz lighting stores have many advantages, but there are still many users who question their reliability, and even some are now The areas where solar street lights are installed are eager to replace them. What is the reason for this? The following is an answer from the landscape lamp manufacturer.

u003cbru003e

u003cbru003e After inquiring, it was found that it was because they bought defective products, whether it is a light source or a battery or a battery panel, all of them are some second-rate or third-rate miscellaneous brands. In the process of use, it is either bad or bad. The maintenance cost of a single set of street lights will cost hundreds of yuan a year. This rated cost has a certain pressure on villages that are not too rich, and the relevant person in charge of street lights has reached a difficult situation. If it’s broken and not repaired, it’s equivalent to spending more than two thousand yuan on the road 'decoration.' Can't change the solar street light to use 220v mains power? This idea is indeed valuable, so is this approach feasible? The answer is yes, there is no problem at all.

u003cbru003eThe components of the solar landscape street light are four major parts: solar panels, light sources, batteries, and controllers. All operating instructions are completed under the cooperation of these four central hardware, which means that there is a problem in any link It will cause the operation of solar street lights to be paralyzed. Unknown hardware is very unstable in current and voltage control. This instability will directly cause damage to the light source.

u003cbru003e

u003cbru003e If the quality of the light source is not too bad, it is not difficult to change the solar landscape street light to mains. You only need to disconnect the controller, the battery and the battery board from the light source, or remove it completely. Use the removed solar modules for indoor photovoltaic lighting). Save the LED light source, install a drive constant current source at the junction of the 220v mains and the light source line (determine the power supply model according to the power of the LED lamp beads and the serial-parallel mode), after the installation of the power supply, the solar street light will completely complete the mains power generation.

u003cbru003eThe above is all the content shared by solar landscape lighting manufacturers.