Guangdong street lamp

30 meters high lamp installation and maintenance: more than 20 meters high lamp by the second quarter splice, the following three 30 meters high lamp, for example, briefly describes its installation details and matters needing attention. Bring the High lamp installation 】 30 meters high lamp installation details and attention affairs ( 1) First will lift system

30 meters high light pole installation and maintenance: 20 meters high light pole most by two paragraphs patchwork. With three 30 meters high pole lights, for example, the installation details and matters needing attention. ▲( High lamp installation] 30 meters high lamp installation details and matters needing attention, 1) First, will improve the system is connected with main wire rope hoist fixed in place, then the main wire rope in turn into the second and third section of the pipeline. ( 2) Plug in, brick or wood will next flat, crane insert in the second quarter and the third quarter, pulling the section on the main oil line of about 1 m, through oil line connection plate and three auxiliary oil thread connection, and then the main oil line from top to bottom will drag about 50 centimeters from oil line connection plate at the top of the position, and then install rainhat. ( 3) Stand up straight, will be three auxiliary oil thread section with the flange connection, using hoist itself as much as possible to tighten the power of the three, and then prepared a long, 30 meters hoisting belt ( Bearing about 4 tons) , with flange motor door fixed, and then use crane to lift. ( 4) In order to prevent lamps and lanterns is damaged in the process of lifting, it is recommended to install lamps and lanterns before connect fission lamp panel and the light pole body. ( 5) Debugging: plate is installed in the parking lot and lamp light, after, the arrival of three auxiliary oil line connected to the lamp panel, and then start the winch promote lamp panel, test whether hook smoothly unload, connect the power supply, complete the installation. Many high lamp is 5 cubic meters underground pit volume, which means that there will be more than 5 m3 of concrete were embedded into the embedded parts, not to mention, 30 meters high lamp. Even on the basis of the installation of 35 meters high light, they will be stable as mount tai. As for the steel pile as a fixed embedded parts, can only say that the choice of the rich. Although more solid than screw steel pile embedded part, but personally I think it is not necessary, because the cost is too high, after all. In addition to the cost of steel pile itself, also need to transfer the driver in the installation process to complete the operation. These costs alone will soon catch up with the cost of a complete set of light. Cannot measure the light, the lowest part of the bottom flange, because welding flanges on the cross section of a pipe body, as long as the welding, no one can measure it. The top and a shackle, can't be measured because the top of the triangle lightning rod fixed plate welding on the diameter of the lid, so you can't measure. However, in the middle of the insert part can be measured. Light, anticorrosive technology is hot dip galvanized and plastic spraying, hot dip galvanized thickness is 85 microns; The thickness of the plastic spraying is 0. 3 mm, the thickness of the two processes together is close to zero. 5 mm street lamp lighting factory (shandong 。 jschindo。 com) Co. , LTD. Is a company specializing in the production of solar street light, high lamp, garden lamp, landscape lamp and led street light. It has more than 15 years of production experience, high quality, low price and honesty. Welcome new and old customers to come to consult.