Frame type signal light pole manufacturers claim to the signal light pole

Light pole height must be chosen according to the road width and usage, wall thickness to achieve more, both inside and outside hot dip galvanized, galvanized layer thickness of 35 m, above, flange thickness above 18 mm, and between flange and light pole to weld reinforcement, to ensure the strength of the bottom of the light pole. The past for

light pole height must be chosen according to the road width and usage, wall thickness to achieve more, both inside and outside hot dip galvanized, galvanized layer thickness of 35 & mu; M, above, flange thickness above 18 mm, and between flange and light pole to weld reinforcement, to ensure the strength of the bottom of the light pole. In the past because of the light pole galvanized unqualified and without welding stiffener, lead to the bottom of the light pole corrosion is serious, blow off the phenomenon of light pole. Light pole, therefore, wall thickness, the thickness of the galvanized and whether to add weld reinforcement is an important symbol of light pole qualified or not, otherwise can't use.

in accordance with the standards for road lighting design: currently in road lighting design, a lot of road illumination on the high side, both increased the power consumption of street lamp lighting, also weaken the effect of road on both sides of the landscape lighting. So when the design according to the city road lighting design standards specified in the illuminance value, intensity of illumination evenness and combined with the actual situation to carry on the design, such as reasonably select light source of lamps and lanterns, do both meet the demand of road surface average illuminance, and can satisfy the requirement of road illumination uniformity, the large extent improve the utilization coefficient of lamps and lanterns, so as to achieve the purpose of saving electricity.