200 watts jin solar street light

Common on the market at present high lamp basic divided into lift and the lift. Lift main stem height above 18 meters, general electric hoist is easy to operate, lamp plate to work place, can automatically set off automatically, hanging ditch, unloading and wire rope. High lamp with us

at present, the common high lamp on the market basically divided into the lift and the lift. Lift the main stem height generally in more than 18 meters, electric lift is easy to operate. After the lamp panel up to the job position, it can automatically remove the panel, hang up grooves, remove the wire rope. Light, inseparable from our life, so how to configure high lamp? The street lamp lighting factory (below 。 jschindo。 com] Is to introduce the daily maintenance of high lamp, mainly including the following: 1. Check all of the black metal artifacts (that is high lighting Including light pole wall) Whether the galvanized anti-corrosion, fastener locking measures is in accordance with the requirements ( Anticorrosion quality should comply with the GB/T9790, GBJ36011 and the related provisions of GB/T11373) 。 2, check the mast lighting verticality ( Must be measured with theodolite regularly according to the requirement and test) , bar allows error should be less than 3 times of high lever; 。 Light pole axis straightness error shall not be greater than 2 times of the light pole length; 。 3. Whether the inspection for the surface and weld light pole of rust. If light pole has been used for a long time, but you can't change again, ultrasonic and magnetic particle testing methods should be used when necessary to detect and test welds. 4. Check the lamp panel, mechanical strength, to ensure the safe use of lamp panel. Check the cooling condition of closed the lamp panel; 5. Check the bracket of lamps and lanterns of the bolt, reasonably adjust the projection direction of lamps and lanterns; 6. Carefully check the lamp panel wire ( Soft cables or soft wire) Usage, see whether or not the wires are too big to mechanical stress, whether there is aging, crack, bare wires, etc. And immediately deal with unsafe phenomenon; 7. Replacement and repair the damaged parts, such as light equipment 8. Check to focus on increasing the transmission system: 9, 10 check power distribution and control equipment. Check electrical safety performance, repair light, check the power supply into line with the insulation resistance between the ground: not less than 10 m11, protective earthing and lightning protection device examination 12. Basic plane of the panel is measured with level, according to the results of check the perpendicularity of the light pole, analysis of uneven settlement of foundation, and carry on corresponding processing. 13. Site regularly measuring high lamp lighting effect. Compared with the ordinary street lamp, mast lamps and lanterns is very convenient to have a larger range of lighting and light source maintenance structure. Which one is better? In everyday situations, when the lamp head has a problem, maintain all height more than 6 m light pole is quite troublesome. Find a mechanical lift truck and manned is very time consuming. Dismantle the damaged lamp, after installation personnel will be raised by forklift to install. Although high lamp more than 18 meters high, but considering the follow-up maintenance, in the design drawings, high lamp manufacturers designed to lift the lamp panel structure, so don't need any mechanical vehicle involves many uncertain factors, the damage of the light source needs only a maintenance personnel can solve the problem, greatly reduces the maintenance cost. Shandong street lamp lighting factory co. , LTD is a company specializing in the production of solar street light, high lamp, garden lamp, landscape lamp and led street light. It has more than 15 years of production experience, high quality, low price and honesty. Welcome new and old customers advice.