20 w solar street light configuration

Once installed solar street lamps, all anxious to see light effect, after the completion of the installation will light on test results. Under normal circumstances, the day after installing solar street lamps generally don't recommend direct electric lights. Because the new battery in the factory time

after installing solar street lamp, in order to see the lighting effect, after the installation is complete, everyone will light up to test the effect. Under normal circumstances, the general solar street light is not recommended in direct electricity installation day. Because the new battery didn't charge at the factory, if light up after installation, can't meet the design of a rainy day. After install the correct method is connecting the controller, rather than the connected load. The next day, a day after charging, evening again connected load, the battery capacity can reach a higher level. Solar street light plate Angle generally designed according to the Angle of 45 degrees, the better ability of charge to ensure that the winter. But the direction Angle is determined by the installation. When the solar panels in the underground assembly, found that the light pole erected after offset Angle. If similar deviation, generally don't adjust once again. ( Solar street lamps) The angular deviation will not only affect the charging way of thinking, can also affect the solar panels voltage under the same intensity of illumination, solar street lamp open time error is bigger. Therefore, when assembled on the ground, adjust the orientation Angle of solar panels to keep consistent as far as possible. Another is the connection between the internal components and solar street lamps controller. Lighting manufacturers recommend solar street lamps, it is best to use waterproof function of the controller, to ensure the long-term stability, and avoid the user changed illumination time. If you use waterproof controller, wiring will be bent into a U shape, because the terminal side down, so that you can prevent water dripping from the line to the controller. Try to use better quality of copper core. Due to the electrical conductivity, current and voltage in the process of output will have a certain loss, this not only increases the power consumption, and in severe cases can lead to led drive power supply cannot work normally.