Garden light manufacturers talk about the packaging of the basic components of garden lights

In the garden lamp sheath line, the blue core represents the negative pole, and the red core represents the positive pole. This rule applies to the connection of solar street lights. Wrap the light pole assembly with an air film cushion with a width of 60cm. The crimping part of the air film cushion is one-sixth of its width (ie 10cm). The joint of the air film cushion needs to be wrapped with remote power tape for 3 times, and then use Straw ropes are wound with an interval of 100±10mm. Strip the sheath of about 200mm from the sheath wire at the lower end of the upper pole assembly, and then mark the 'solar cell module' mark on both ends of the solar cell module sheath wire for the garden lamp, and make sure that the mark is clear and not easy to fall off . In the courtyard lamp, use a wire stripper to strip the 30mm wire skin of the prepared solar battery module wire to the battery module end, pass the wire core through the hook of the thin iron wire and fold it back, then tighten the wire core, and then use the insulating tape to tighten the wire The core and the thin iron wire are firmly fixed. Pull the iron wire at the top of the upper light pole to take out the component wire and leave a margin of 500mm～1000mm. Reel the component wire at the bottom end of the upper light pole and tie it with a 200mm nylon cable tie. Put it into the upper light pole, and fix the component wire at the top of the upper light pole on the light pole. There are generally two sheath wires for solar cell modules. Therefore, two wires should be pre-threaded when pre-threading the wires, and then the jacket wires should be worn one by one. After the courtyard lamp wears a solar cell module sheath line, mark the two ends of the sheath line and fix the upper end immediately.