Explosion-proof azimuth lamp FL4800 for traffic police and fire protection produced by lighting factory

Explosion-proof azimuth light FL for traffic police and firefighting. Produced by the lighting factory today, I recommend a FL explosion-proof azimuth light that can be used as warning signs in various special dangerous places. It is also suitable for construction, operation and monitoring, rescue, and rescue workers. Used for signal contact and position display. Equipped with two high-energy batteries, the continuous working time is more than hours. Corrosion resistance: Due to the special surface protection treatment of the selected materials, it can work normally in a strong corrosive environment. It is small in size, light in weight and easy to operate. It can be carried by hanging, clip, binding and magnetic adsorption. It can work normally at -°C cold or at high temperature. There are many colors such as red and warning yellow. Refined with American bulletproof rubber material to ensure that the product can withstand strong collisions and impacts. Fully dense process design, underwater working depth can reach up to meters. Visible to the naked eye within meters (miles); penetration ability to water and rain and fog is -m intrinsically safe * high explosion-proof grade, and can work safely in various flammable and explosive places (including areas). Use and 2. Use the battery installation screwdriver to unscrew the stainless steel screw at the bottom of the flash, pull the shell apart, and install the battery in the battery box according to the marked polarity. After the battery is installed, push on the casing and tighten the above screws (note: carbon steel screws cannot be used instead of stainless steel screws). To ensure flash time and brightness, it is recommended to replace new batteries in time. , Turn on and off Press the rubber button on the upper part of the lamp to turn on or off the azimuth light. , Wearing method: Clipping: Pull open the pressing piece, the elastic piece and the shell will automatically open, snap into the soft support, press down the pressing piece, and then it can be fixed on the support. Hanging: Hang on the support with a hanging ring. Bundle: Use sticky tape to tie it on the arm or other parts of the body.