Come and understand, how to design solar street lights for windproof?

I believe everyone knows that in some places with high wind speed and large air volume, almost every year there are accidents of light poles being blown down by the wind, and the damage of lamps due to wind is more common, and the phenomenon of wind dust causes the brightness of the lamps to be seriously attenuated. important reason. Therefore, when we choose solar street lights, we must not only consider its beauty and use functions, but also pay attention to the windproof and dustproof functions of lamps and poles. Only in this way can we ensure the safe use of street lights in urban infrastructure. , Bring convenience to everyone's travel and life production. What needs to know about the windproof foundation of solar street lights: u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003e One: Lamps—As an important part of street lamps, the quality and opening method of lamps are very important. The material must be cast aluminum alloy, and the thickness must meet the requirements. No cracks or holes in the lamp body are allowed, and all parts are connected. There must be good contact points at all places, and the buckle part is the most important thing. Because of the unreasonable buckle design of the previous lamps, a large number of lamps are damaged after each strong wind. Therefore, spring buckles should be used on the lamps. It is best to install two. The upper part of the lamp is opened directly, and the important parts such as the ballast are fixed on the lamp body to prevent the parts from falling off after the lampshade is damaged. u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003e Second: Light pole—The height of the light pole must be selected according to the road width and usage conditions, the wall thickness must be above 3.5mm, the inside and outside hot-dip galvanized, the thickness of the galvanized layer is above 35μm, and the thickness of the flange is above 18mm. In addition, reinforcing ribs should be welded between the flange and the pole to ensure the strength of the bottom of the pole. In the past, due to the unqualified galvanization of the lamp pole and the lack of welding reinforcement, the bottom of the lamp pole was seriously corroded, and the phenomenon of the lamp pole being broken by the wind occurred from time to time. Therefore, the wall thickness of the pole, the thickness of galvanization and whether to add welded reinforcing ribs are important signs of whether the pole is qualified or not, otherwise it cannot be used. u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003e u003cbru003e Third: Foundation—As a concealed project of street lamp engineering, street lamp foundation is also a very important part of the overall windproof and safe use of street lamps. First, choose C20 concrete for pouring. The choice of anchor bolts depends on the height of the pole. For 8m poles, choose Φ20 bolts with a length of 1100mm and a foundation depth of 1200mm; for 10m poles, choose Φ22 bolts with a length of 1200mm. The base depth is 1300mm; the 12m light pole should choose Φ22 bolts, the length is 1300mm, and the base depth is 1400mm; the lower part of the foundation is larger than the upper part, which is conducive to the stability of the foundation and enhances the wind resistance.