How light, solar lamp posts how to install high lamp

by：ALLTOP 2021-02-03

The installation of light; 1. According to the loading and packing list carefully counted all artifacts. 2. Check whether the component is damaged, bend, twist, zinc layer is damaged. 3. Each section on the rod body signs indicate the type of the rod body, order number, block number. In the rod body side color with

high lamp 【 Light, generally refers to more than 15 meters steel conical light pole and high-power modular fixtures are composed of new type of lighting. 】 The installation;

1. According to the loading and packing list carefully counted all artifacts.

2. Check whether the component is damaged, bend, twist, zinc layer is damaged.

3. Each section on the rod body signs indicate the type of the rod body, order number, block number. In the bar side of the body to indicate the weight of the rod body with a marker pen. Is issued by the cargo is correct, the crane lifting capacity is enough.

4. On the basis of drawing on the maximum and minimum socket length, in the good mark in the rod body, used for the socket.

5. Each joining together a full length, but because of the influence of manufacturing, and installation error and physical factors, there is the change of the socket length, so the minimum set of chengdu street lamp length and maximum length of the socket.

6. In order to make the installation is convenient, may require lubrication fitting surface. Notice shall not be used lubricating oil to prevent leakage and pollution of the rod body, can use soap water lubrication socket inside and outside surface.

7. The socket should exert the necessary force at both ends, when to get close the socket.