How about the lifting system of the high pole light? What are the hard target requirements?

The high pole light is the most common device in any place because this kind of device basically appears in any corner of the city or the countryside. It can be seen that when we walk in the market on the main road, everywhere They are all high pole lamps. How much do you know about the lifting system of the whole equipment? Everyone may have some opinions about this kind of equipment. At present, the lifting system of the whole equipment must be different.

(1) The lifting system of the high pole lamp equipment can be actually processed by the built-in independent electric coil factory mechanism. The entire whole mechanism is equipped with a special locking device, and it can be carried out through a long distance of 5 meters from the hole. side operation.

(2) An adjustable independent torque limiter can be installed between the high pole light equipment tool and the hoist, and this equipment can prevent overload. The entire equipment can use an electric lifting mechanism and can be jogged by electric means, It is required to do manual operation when forging cracks, but everyone must pay special attention during the operation.

(3) The lifting system of the high pole lamp should adopt a relatively flexible stainless steel wire rope, and all design safety factors should not be less than 6. It is best for all production organizations to set up the entire equipment during the operation process, and the shedding device should ensure that all steel wires in the breakage are stuck in time and do not fall off at the same time.

Through the above introductions, I believe that most people must also be very concerned about the lifting system of high pole lamps. Then such a device lifting system can be fully adjusted for actual experience and effectively achieve the desired lifting height.